Require 4 -6 Weeks upon order confirmation
The SCS 724 Workstation Monitor continuously monitors the path-to-ground integrity of two operators and one conductive or dissipative worksurface. It has been designed and tested for use with SCS Dual-Wire Wrist Straps and Worksurface Mats. If the equipment is used in a manner not specified in these instructions, the protection provided by the equipment may be impaired. Use in any other application has not been evaluated by SCS and may lead to an unsafe condition.
The SCS 724 Workstation Monitor meets the requirements of ANSI/ESD S20.20 and recommendations of ESD Handbook ESD TR20.20 which includes “if the products that are being produced are of such value that knowledge of a continuous, reliable ground is needed, and then continuous monitoring should be considered or even required”.
- Single workstation continuous monitor
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-01 - Continuously monitors 2 operator dual-wire wrist straps and 1 worksurface mat
Visible and audible alarms indicate improper grounding of the operator and worksurface. - Adjustable operator test voltage and upper limit
Test voltage can be set to 9 or 16 volts; test limit can be set to 10 or 35 megohms. - Adjustable audible alarm
Buzzer volume may be disabled or set to loud or soft. - Simple installation and setup
Mounting hardware and wire management clips are included. - Power adapter not included
724-PSEU power adapter sold separately for European and UK outlets - 724VK2 Calibration Verification Tester sold separately
Use to perform periodic calibration testing of the 724 Workstation Monitor. - NIST Calibrated
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology